'Rondas' ring pulls are simply designed with a range of motion exceeding 90 degrees. Affixes from the rear with a single machine screw.
Features:
- At 40mm wide each pull will easily fit a single finger.
- Suitable for most drawers and cupboards so long as the weight is not too great (remember that only a single finger is being used to pull).
- Available in satin black.
- 25mm and 30mm M4 screws are included so as to provide greater flexibility when fitting.
Specifications & Dimensions:
Material: Zinc.
Finish: Satin black.
Width: 40mm (at maximum).
Height: 42mm (at maximum and including the base).
Projection: 11mm (also commonly referred to as depth).
Width of Base: 12mm
Height of Base: 12mm
Fastener(s) Required: M4 machine screw(s) (25mm and 30mm are included by default).
Important Information:
These ring pulls have a range of motion slightly exceeding 90 degrees (about 120 degrees at maximum). A standard installation will have the pulls laying flat against the front of the substrate (a drawer panel etc) with gravity holding them in this vertical position. They can be lifted more than 90 degrees, into a slightly more that horizontal position. However, further than this and you risk forcing the ring part against the base (causing damage to the finish over time).
Warranty:
Structural: 2 years.
Finish: 1 year.